Pilot FC1 Elster jet 3m met pipe en tank (geen retracts) 01

Omschrijving

Opmerking : Deze kit is zonder retracts maar inclusief tailpipe en tank.

Pilot-RC is zeer trots om een nieuwe samenwerking aan te kondigen met de onbetwiste pioniers van 3D jet vliegen en ontwerpers van die allereerste 3D J10, Ralph en Enrico van Elster Jet.

Deze nieuwe samenwerking heeft geleid tot de productie van Pilot-RC's nieuwste ontwerp, de FC1.

Ontworpen om zowel nauwkeurig en zeer capabel te zijn in normale aerobatics en ook extreem wendbaar en licht voor 3D vliegen. Elster's achtergrond in 3D jet vliegen heeft geleid tot een aantal innovatieve oplossingen die zorgen voor een licht, sterk en uiterst capabel en leuk nieuw vliegtuig om te vliegen.

Features

• Model: FC1
• Wingspan : 74.8″ (1,900mm)
• Length: 120″ (3,055mm)
• Wing area : 1,734″2 (11,190cm2)
• Weight : 31.0lbs (14.1kg) with JetCat P220Rxi turbine and full UAT

FEATURES:

• German design, by Ralph and Enrico from Elster Jet, designers of the first J10’s
• Extremely lightweight full composite construction especially designed for outstanding 3D performance
• Painted outside the mold so no seam lines
• Ultra strong and light weight landing gear mounts, with factory installed blind nuts so mounting is just plug and play
• Split fuselage design is joined with 5 screws, with only batteries and nose gear installed in the front section, meaning very easy connections and quick assembly at the field
• Specially designed easy access to turbine for speedy installation
• Wings and elevator are secured from the top
• Removable wing and elevator for easy transport
• Please note that the FC1 is designed specifically for aerobatics and 3D vectored flight, with light weight being key. It is not designed to be used as a full power, high speed race plane.

INCLUDED HARDWARE:

• Complete air frame (including carbon wing-tubes and preinstalled and painted fibreglass control horns)
• Servo extension leads
• Vector thrust pipe
• 4.500ml fuel tank
• 250ml UAT tank
• Pre-prepared pushrods with ball links

REQUIRED HARDWARE:

Turbine size:

• 140-190N  for normal sport flying
• 200-260N for 3D vector flight – Avoid high speed, high G flying

• Servos: Total x10 (x9 standard size + x1 medium size) 
• x9 standard size high torque
• x2 for ailerons (minimum 35kg)
• x2 for flaps (minimum 20kg)
• x1 for vector elevator (minimum 20kg)
• x1 for vector rudder (minimum 20kg)
• x2 for elevators (minimum 20kg)
• x1 for rudder (minimum 20kg)
• x1 medium size servo for steering (size: 35x15x30mm)

Also requires all the usual accessories such as transmitter, receiver, batteries, powerbox and possibly other small accessories.