The servo programming device DPC-11 (dongle PC) is used for programming/adjusting and testing HiTEC digital servos with the PC. Especially when you have to adjust several servos, the clear PC software simplifies the setting. Suitable for the following HiTEC servos: HS-5XXX, 7XXX, HSB-9XXX and the new D series
Programmable features:
- Setting the middle and end points (180° function)
- Setting the direction of rotation (clockwise/counterclockwise)
- Setting the dead zone (electronic "game")
- Adjusting the speed (servo can be made slower)
- Adjusting the soft start (servo runs slowly to its neutral position when first switched on)
- Setting the fail-safe function
- Setting the overload protection (servo becomes “soft” if overloaded for too long, which in the worst case prevents it from burning out)
- Save or load settings
- Factory reset
Operating voltage 4.8 - 8.4V, depending on the servo type
The associated software is available free of charge in the download area of the Multiplex / Hitec homepage.
A must for every HiTEC servo owner!
