General Air module 2-6S for HOTT
General sensor for Graupner HoTT receiver and models with internal combustion or electric motor. 2-6s.
- Vario with altitude signals and 5 each climb and Sinktönen
and additional warning thresholds for min. Height, max. Altitude, climb and
descent rate in two stages
- Altitude display (- 500 ... + 3000 m) and storage of min.
and max. Height.
- 2x temperature and voltage measurements with warning
thresholds for min. and max. Voltage and min. and max. temperature
- Single cell measurement with warning thresholds for min.
- Voltage, current and capacity measurement with warning
thresholds for min. and max. Voltage, max. Capacity and max. electricity
- Programmable current limit
- Current measurement with shunt resistors 2x 1 mOhm parallel
= 0.5 mOhm
- Speed measurement and warning thresholds for min. and max.
number of revolutions
- Fuel measurement with warning thresholds in 25% increments (for software update).
- Adjustable warning time: OFF, 5, 10, 15, 20, 25, 30 seconds, always
- Adjustable Warning repeat time: Always, 1, 2, 3, 4, 5 min, once
- Important note when using the modules 33600, 33601, 33610, 33611 and 33620:
- Take during the flight any programming work on the sensors,
so that your model can not fall through carelessness out of control!
- When using two or more receivers in the model you can not
make in no case programming during the flight, as this may lead to incorrect
settings in the receivers without connected telemetry and thus in the worst
case the model crashing! Therefore, program always on the ground and make sure
that only to be programmed receiver is turned on with the connected sensor.
- 2x temperature optionally from 0 to 120 ° C or 200 ° C and voltage measurement to 60 V DC
- 1x speed measurement to 100 000 rev / min with a two-bladed propeller,
- 1x speed controller / servo input, 1x input speed control, 1x speed controller / servo output for speed control
- 1x current and voltage and capacity measurement up to 40 A (pulse 1s: 60 A) and to 30 V
- 1x single-cell monitoring for 2 - 6S lithium batteries (LiPo, Lilo or LiFe)
- 1x receiver power supply input and output
- 1x telemetry connection for receiver
- 1x fuel sensor 0% / 25% / 50% / 75% / 100%
- Altimetry: -500 m ... +3000 m
- Resolution: 0.1m
- Sensitivity Vario: 0.5m / 3s, 1 m / 3 s, 0.5 m / s, 1 m / s 1, 3 m / s per tone programmable
4 - 20 measurements per measured value programmable